PRODUCTS

Saw Setting Dial Gauge
Saw Setting Dial Gauge
+
  • Saw Setting Dial Gauge
  • Saw Setting Dial Gauge

Saw Setting Dial Gauge

subcategory

  • Product description
  • Specifications
  • Features

    The gage conveniently has two faces, one on each side for right and left handed use. The dials are movable and each side has a tolerance marker. For use, the gage is laid on the saw blade so that the contact point touches the cutting edges of the saw. The pointer gives an instant reading of the measurement.

     The standard flat feeler shown on the gage above has a   diameter of 10 mm (.4").

     Used to check the tooth set on steel saw blades and measure   the tangential and radial side clearance of circular saw blades

     Kafer standard Saw Setting Dial Gauges are supplied with a   flat contact point 10 mm diameter.

     The specific contact point are available on demand. Please   note that the contact points are not interchangeable.

     Side Dial Gauge (Set Gauge) is delivered with Storage Case

     As standard Saw Setting Dial Gauges are supplied with a flat   contact Carbide anvil 10 mm diameter. Please note that the   contact points are not interchangeable.

     Notes: On both sides for left or right handed use.

  • Model No

    Range mm

    Reading mm

    Bezel mm

    Feeler mm

    P5076-2

    2 mm

    0.02 mm

    Ø 40 mm

    Ø 10 mm

    P5076-0.08

    0.080”

    0.001”

    Ø 1 9/16”

    Ø 10 mm

     

Send message
%{tishi_zhanwei}%